Network connection problems Neoware

[spameiro]

Hi,
I've got thin client Neoware EON 2000E with network card onboard.

After the boot completes there is no network connection. I'm connected to a typical router with dhcp turned on. What do I need to do to get the network connected?

-dmesg
NET: Registered protocol family 24
8139too Fast Ethernet driver 0.9.28
PCI: setting IRQ 15 as level-triggered
PCI: Assigned IRQ 15 for device 0000:00:0f.0
eth0: RealTek RTL8139 at 0xc4818000, 00:e0:c5:62:3a:9d, IRQ 15
eth0: Identified 8139 chip type 'RTL-8139C'

-lsmod
Module                  Size    Used by
parport_pc         28440    0
parport               29012   1 parport_pc
ohci_hcd             19076   0
scsi_wait_scan     2176   0

-lspci -v
00:0f.0 Ethernet controller: Realtek Semiconductor Co,. Ltd. RTL-81139/8139C/8139C+ 9rev 10)
Subsystem: Realtek Semiconductor Co., Ltd. RT8139
Flags: bus master, medium devsel, latency 32, IRQ 15
I/O ports at e000 [size=256]
Memory at d8000000 (32-bit, non-prefetchable) [size=256]
Kernel driver in use: 8139too

Tia
S.

[curaga]

Please also post "ifconfig eth0"

[spameiro]

-ifconfig eth0
eth1    Link encap:Ethernet HWaddr 00:E0:C5:64:3A:9D
           UP BROADCAST RUNNING MULTICAST MTU:15000 Metric:1
           RX packets:0 errors:0 dropped:0 overruns:0 frame:0
           RX packets:0 errors:0 dropped:0 overruns:0 carrier:0
           collisions:0 txquelen:1000

I haven't connection between router and network card. Cable and network card are fine, under Windows works normally.

[roberts]

I was demo'ing a mini-itx via system with a rtl8139C during the Scale7x expo and it worked fine.
When I came home it did not. Changed the cable and is working great here.
Note that the rtl8139 wants to connect at 100Mbps