WelcomeWelcome | FAQFAQ | DownloadsDownloads | WikiWiki
« previous next »
Pages: [1]   Go Down

Author Topic: boot code xvesa=WxHxD cannot work in 2.8  (Read 1868 times)

Offline exon

  • Newbie
  • *
  • Posts: 2
boot code xvesa=WxHxD cannot work in 2.8
« on: January 25, 2010, 08:39:49 AM »
Hi, I have found the boot code that workable in TCL 2.7 is no longer work in TCL 2.8.  Do somebody else has this problem also?

Thanks
 
Logged

Offline roberts

  • Retired Admins
  • Hero Member
  • *****
  • Posts: 7361
  • Founder Emeritus
Re: boot code xvesa=WxHxD cannot work in 2.8
« Reply #1 on: January 25, 2010, 10:49:38 AM »
Working fine for me. base norestore xvesa=800x600x24 Note that .xsession from backup trumps.
Logged
10+ Years Contributing to Linux Open Source Projects.

Offline exon

  • Newbie
  • *
  • Posts: 2
Re: boot code xvesa=WxHxD cannot work in 2.8
« Reply #2 on: January 25, 2010, 11:04:37 AM »
Hi Robert, thanks for your help.

By using the boot code: base norestore xvesa=800x600x24 , I can successfully boot TCL 2.8 with 800x600 resolution.

However, when I use the boot code in the kernel line:
kernel /boot/bzImage quiet xvesa=800x600x24, I still can't boot with 800x600 which I haven't any problem in TCL 2.7.



Logged

Offline gerald_clark

  • TinyCore Moderator
  • Hero Member
  • *****
  • Posts: 4254
Re: boot code xvesa=WxHxD cannot work in 2.8
« Reply #3 on: January 25, 2010, 06:04:57 PM »
As roberts said, check your .xsession.  It overrides the boot code.
Logged
Pages: [1]   Go Up
« previous next »