WelcomeWelcome | FAQFAQ | DownloadsDownloads | WikiWiki
« previous next »
Pages: [1]   Go Down

Author Topic: Startx problem  (Read 1361 times)

Offline MrToga

  • Full Member
  • ***
  • Posts: 142
Startx problem
« on: April 21, 2022, 05:08:07 AM »
Hello guys,

When I use the command startx in the prompt the GUI doesn't run on my screen and I only get in return to this command :
1 cycle done
But when I reboot the GUI is running fine.
Any tought?
Logged
It's fine

Offline Rich

  • Administrator
  • Hero Member
  • *****
  • Posts: 11695
Re: Startx problem
« Reply #1 on: April 21, 2022, 10:45:25 AM »
Hi MrToga
If you got to the prompt by hitting  Ctrl-Alt-F1  it's because X is still running. Then, the way back would be  Ctrl-Alt-F2.

Otherwise, describe how you got to the prompt and whether your RPi has an attached keyboard and monitor. I don't
run any RPi hardware so you'll have to wait and see if any of the smart kids have any ideas.

Logged

Offline MrToga

  • Full Member
  • ***
  • Posts: 142
Re: Startx problem
« Reply #2 on: April 21, 2022, 10:51:49 AM »
Hi Rich,

I think it was because I was doing ctrl alt f1 and I didn't know i could get back with ctrl alt f2

Thank you ;D
Logged
It's fine
Pages: [1]   Go Up
« previous next »