Tiny Core Base > Other architectures
piCore for the H3 boards - Orange Pi, Nano Pi etc.
jgrulich:
The only way how to get the system messages during boot is to use the serial debug console, please find some COM, or USB one and connect to the board.
jgrulich:
How did you wrote the bootloader to the eMMC? Which one you've used?
nxtv2.0:
Ok i will try all zimage files i see.
I used the eMMC with armbian and it worked flawlessly, using the nand-sata-install command.
i just wrote the image.img file to the eMMC using dd as if it was just a micro-sd card
nxtv2.0:
--- Quote from: jgrulich on October 19, 2016, 03:27:16 AM ---Understand that you used all three files from Rev2 folder, but I need to test all the zImage files, including:
https://dl.dropboxusercontent.com/u/86461636/Rev1/zImage
https://dl.dropboxusercontent.com/u/86461636/zImage
--- End quote ---
Both don't work.
nxtv2.0:
Can you please list the commands needed to install piCore to eMMC as i can't install it myself and am a complete noob.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version