USB/IP

[Project23D]

while ser2net works great for reading and writing commands to the Arduino, the arduino IDE does not, however, allow me to program the arduino.

I see there is a program/daemon called USB/IP that is on a host and client, and is recognized by Arduino IDE.

I also see that TCE repository 4.x and 5.x does not have USBIP, it was though, in TCE 2.x

given that it was repository before, what, if anything, will need to be done to make it work with 4.x or later?

[Rich]

Hi Project23D
I don't see any packages called  usbip  in the 2.x repository.

[Project23D]

oops, I was looking at the kernel and thinking of something else.

It is in the 3.x repo.

I tried what you mentioned for ser2net for usbip, but haven't fully figured it out yet.

[Project23D]

I tried doing wget ../.. usbip-2.6.33.3-tincore.tcz and usbip.tcz, then then a tce-load -i ..

no dice.

ideas?

[tinypoodle]

Those modules could only be loaded with a 2.6.33.3 kernel.

[Project23D]

ok.

Then let it be requested that USB/IP is made to work with 4.x or 5.x.

[Rich]

Hi Project23D
Extension requests can be made here:
Tiny Core Extensions » TCE Talk » Extension requests

[bmarkus]

USBIP added to 5.x (x86) repo

[Project23D]

Thank you!!!

de KB9LFZ
~Benjamin

[bmarkus]

Thank you!!!

de KB9LFZ
~Benjamin

I'm playing with FUNCUBE dongle receiver connected to a Raspberry Pi. RPi itself is too slow to run WEBSDR, the plan is to run it on fast x86 machine having receivers remote. Will see wheter USBIP is useble for this or not.

73...

[Project23D]

I have usbip installed, and sorta working.

I can get it to list the USB devices locally attached to the machine, but when trying to perform

Code: [Select]

usbip bind -b 2-2

I get an error message saying that is cannot bind to the device

[bmarkus]

Would be good to see output of lsusb and exact copy of terminal commands and messages.