WelcomeWelcome | FAQFAQ | DownloadsDownloads | WikiWiki

Author Topic: New to TC and need help setting up the GUi  (Read 3989 times)

Offline efranor

  • Newbie
  • *
  • Posts: 4
New to TC and need help setting up the GUi
« on: March 12, 2013, 07:17:31 AM »
So I'm new to TinyCore and I have an Igel Thin Client on which I installed TinyCore.
At first I thought that the hardware was at fault. But after reading the documentation and following it (for a second install) I found that the GUI does not even want to boot at the USB installation. After the VGA menu passes (and I enter all the options in with TAB) I just get a CLI.

Offline tinypoodle

  • Hero Member
  • *****
  • Posts: 3857
Re: New to TC and need help setting up the GUi
« Reply #1 on: March 12, 2013, 07:36:31 AM »
Try
Code: [Select]
xsetup
"Software gets slower faster than hardware gets faster." Niklaus Wirth - A Plea for Lean Software (1995)

Offline efranor

  • Newbie
  • *
  • Posts: 4
Re: New to TC and need help setting up the GUi
« Reply #2 on: March 12, 2013, 07:55:14 AM »
Tried with F3 seems that my graphics card is not supported.

Offline efranor

  • Newbie
  • *
  • Posts: 4
Re: New to TC and need help setting up the GUi
« Reply #3 on: March 12, 2013, 09:50:58 AM »
The problem was in my hardware. Seems that the graphics card is tad disconnected and needs to be reconnected from time to time.