Hi,
I've got thin client Neoware EON 2000E with network card onboard.
After the boot completes there is no network connection. I'm connected to a typical router with dhcp turned on. What do I need to do to get the network connected?
-dmesg
NET: Registered protocol family 24
8139too Fast Ethernet driver 0.9.28
PCI: setting IRQ 15 as level-triggered
PCI: Assigned IRQ 15 for device 0000:00:0f.0
eth0: RealTek RTL8139 at 0xc4818000, 00:e0:c5:62:3a:9d, IRQ 15
eth0: Identified 8139 chip type 'RTL-8139C'
-lsmod
Module Size Used by
parport_pc 28440 0
parport 29012 1 parport_pc
ohci_hcd 19076 0
scsi_wait_scan 2176 0
-lspci -v
00:0f.0 Ethernet controller: Realtek Semiconductor Co,. Ltd. RTL-81139/8139C/8139C+ 9rev 10)
Subsystem: Realtek Semiconductor Co., Ltd. RT8139
Flags: bus master, medium devsel, latency 32, IRQ 15
I/O ports at e000 [size=256]
Memory at d8000000 (32-bit, non-prefetchable) [size=256]
Kernel driver in use: 8139too
Tia
S.