Tiny Core Linux
Tiny Core Base => TCB Q&A Forum => Topic started by: lumosy on March 20, 2011, 06:10:26 PM
-
I installed TC on a VMware VM. It works well.
On boot, it is set to DHCP. I manually changed the IP address to a static one and now I want it to be retained across shutdowns/reboots.
How do I do that?
BTW, I tried to follow the instructions for Frugal Install Tiny Core Linux (http://www.tinycorelinux.com/install.html) but for some reason TC can't see any additional drives added by VMWare. The only thing 'fdisk -l' sees is /dev/ramzswap0.
How do I get TC Linux to recognize additional hard drives added to the VM?
-
if you use the nodhcp boot code, then the dhcp client will not be started on boot. you can put your commands for a static network interface like
ifconfig eth0 192.168.1.2 netmask 255.255.255.0
route add default gw 192.168.1.1
echo "nameserver 192.168.1.1" >> /etc/resolv.conf
into /opt/bootsync.sh and backup that file in /opt/.filetool.lst with the command filetool.sh -b hda1.
if you want to use vmware drives, be sure to use IDE drives, the SCSI ones need drivers from scsi-2.6.33.3-tinycore.tcz. I'm only using IDE drives with vmware since I found no benefit of using the scsi ones besides of more trouble to get them to work ;)
-
if you want to use vmware drives, be sure to use IDE drives
Thank you very much! That's exactly what I needed to proceed with the cfdisk procedure (http://www.tinycorelinux.com/install.html) (which works very well for a VMWare virtual disk, except that "CD" ejecting and setting to boot from /dev/hda1 in BIOS is a bit trickier).
As for your tip for retaining a static IP, I haven't tried it because I found an easier way: Once the cfdisk procedure was completed successfully, I just select the "Save configuration" radio-button in the Control Panel > Network dialog box. When I reboot, it is automatically saved into backup in /hda1/tce.