Tiny Core Base > TCB Q&A Forum

eGalax touch screen

<< < (6/7) > >>

Juanito:

--- Quote from: Tuftec on May 02, 2011, 02:55:13 AM ---I have waitusb=15 set.
I am not sure that is the problem.
I can try waitusb=30 or so to see what happens.

--- End quote ---
I'd say 15 seconds is already more than enough


--- Quote ---The problem (error messages) show up when you plug the touchscreen in with the system running. Not just on boot up. Does waitusb influence this as well as at boot?

--- End quote ---
No, waitusb is only for the initial boot.

I wonder if the usb interface of your touchscreen is buggy or defective - is there a firmware update or similar available?

tinypoodle:
As the device seems to be recognized despite error output, you could still proceed with configuring and running gpm and just see what will happen   ;)

Tuftec:
I tried that, but GPM (as from the TC repository) does not seem to respond to all the necessary command line options (like -R) it throughs up an error.
Maybe I am doing something wrong?

smultita:
try: sudo evtest /dev/input/eventX
and check the events, if they report under type 3 (absolute) you could use
http://forum.tinycorelinux.net/index.php?topic=9146.msg51729#msg51729

Tuftec:
I tried evtest, but the touchscreen does not appear to show up in the list.

Navigation

[0] Message Index

[#] Next page

[*] Previous page