Tiny Core Base > TCB Bugs
I/O dev fd0
jpeters:
with 1.2.rc2 tinycore.gz: hangs (total 60" +) with several iterations of "end-request I/O fd0 sector 0 " and "buffer I/O error device fd0.." before completing boot on a Dell C610 laptop with no floppy drive. No problem with 1.0. Floppy drive is (correctly) listed as "not installed" in bios.
roberts:
Cannot reproduce. Most of my machines have no floppy.
But lets try a few things...
What happens when v1.1 is used ?
What happens with 1.2rc2 booting with nofstab boot option?
Jason W:
I have noticed these messages too along with the same delay time. But honestly it never bothered me enough to check into it. I figured it was maybe something to do with my individual setup. Most my machines have valid and usable floppies though. I will look at it some more when I get home to my TC machine and see if I can't locate the issue.
Versions prior to the latest release candidate did not produce this message or delay.
curaga:
Hmm.. I've never seen this yet on any machine I have, either with floppy drives or without. I did get a small delay when I added a sata dvd drive, probably because all sata drivers probe it, but that's unrelated.
jpeters:
works fine with 1.1. On the Dell, the boot delay with 1.2.rc2 is very noticable with because it hangs over 50 seconds seconds for each for several retries.
edit: same with nofstab. The only difference is the hang occurs before loading eth0 vs after.
Navigation
[0] Message Index
[#] Next page
Go to full version