WelcomeWelcome | FAQFAQ | DownloadsDownloads | WikiWiki

Author Topic: Retaining alsamixer settings between boots  (Read 6424 times)

Offline SamK

  • Hero Member
  • *****
  • Posts: 713
Re: Retaining alsamixer settings between boots
« Reply #15 on: August 21, 2010, 08:39:02 AM »
I'm not clear what you're referring to.

Offline tinypoodle

  • Hero Member
  • *****
  • Posts: 3857
Re: Retaining alsamixer settings between boots
« Reply #16 on: August 21, 2010, 08:57:26 AM »
I couldn't see how any option except from -s and unlikely -a would depend on the existence of a backup.
« Last Edit: August 21, 2010, 08:59:57 AM by tinypoodle »
"Software gets slower faster than hardware gets faster." Niklaus Wirth - A Plea for Lean Software (1995)

Offline SamK

  • Hero Member
  • *****
  • Posts: 713
Re: Retaining alsamixer settings between boots
« Reply #17 on: August 21, 2010, 09:22:54 AM »
I have not downloaded or run the script. My comments were solely based on the information given in posts in the thread referred to.

Offline tinypoodle

  • Hero Member
  • *****
  • Posts: 3857
Re: Retaining alsamixer settings between boots
« Reply #18 on: August 21, 2010, 09:36:12 AM »
Well if you carefully read the whole thread, the option depending on backup was only added at a later stage as an extra  ;)

What i had in mind that this script is ideal even for your non-default setup to determine which files to back up (in whatever way you wish to do so)  ;)
"Software gets slower faster than hardware gets faster." Niklaus Wirth - A Plea for Lean Software (1995)

Offline oldgit485

  • Newbie
  • *
  • Posts: 18
Re: Retaining alsamixer settings between boots
« Reply #19 on: August 21, 2010, 02:00:14 PM »
  Alsa on IBM Thinkpad , curaga and clach04 rock!
Will try to keep it brief:
After 2.8 could not get Alsa to work, just noticed wiki "Setting up sound" had changed, followed the directions, blacklisted the cs_4610 card in boot options applied the persistence instructions in the wiki and it all works beautifully.So read the wiki and use the settings the guys give hope it works for you
Thanks Guys
oldgit