Tiny Core Base > TCB Q&A Forum

computer locks up during hard drive install (twice)

<< < (3/12) > >>

ejames82:
here's the pics.

http://img534.imageshack.us/img534/1728/img0317dg.jpg
http://img594.imageshack.us/img594/7155/img0318i.jpg
http://img707.imageshack.us/img707/2473/img0319wj.jpg
http://img176.imageshack.us/img176/5048/img0320m.jpg

at this point, i have not ran the command "cp -p /mnt/hdc/boot/* /mnt/hda1/boot/"
that's next.

also, i did not run the "dmesg" command for the pics because the output is more than i could take pics of.  the battery is running low on the camera and i had to decide which pics to get first.  is there any part of the "dmesg" output that is crucial to get?
thanks for the replies.

batnas,
i just noticed your reply.  i will try that because it appears the photos are not very good.  we'll see how it goes.

ejames82:
i was unable to figure out how to get a flash drive to do me any good.  i don't know how to access it.

batnas:
If you use a USB stick, you should be able to mount it like the hda...
most likely:

--- Code: ---sudo mkdir /mnt/sda1
sudo mount /dev/sda1 /mnt/sda1
--- End code ---

ejames82:
batnas,

sudo mkdir /mnt/sda1
terminal: file already exists

sudo mount /dev/sda1 /mnt/sda1
terminal: device or resource busy

i think it's all ready for me to use.  i just don't know how.  i already have it plugged in. 
i'll see if i can't access the app you spoke about earlier.  maybe that can shed some light on the subject.
thanks.

batnas:
If the USB-pen is already mounted you can save files like every other folder...

Geany and beaver are texteditors .

\\Batnas

Navigation

[0] Message Index

[#] Next page

[*] Previous page