dvb-s skystar2 don't work

[exi]

dmesg result...

Code: [Select]

b2c2-flexcop: B2C2 FlexcopII/II(b)/III digital TV receiver chip loaded successfully
flexcop-pci: will use the HW PID filter.
flexcop-pci: card revision 2
b2c2_flexcop_pci 0000:05:04.0: PCI INT A -> GSI 16 (level, low) -> IRQ 16
DVB: registering new adapter (FlexCop Digital TV device)
b2c2-flexcop: reading of MAC address failed.

b2c2-flexcop: i2c master_xfer failed
b2c2-flexcop: i2c master_xfer failed
CX24123: cx24123_i2c_readreg: reg=0x0 (error=-121)
CX24123: wrong demod revision: 87
b2c2-flexcop: i2c master_xfer failed
b2c2-flexcop: i2c master_xfer failed
b2c2-flexcop: i2c master_xfer failed
mt352_read_register: readreg error (reg=127, ret==-121)
b2c2-flexcop: i2c master_xfer failed
nxt200x: nxt200x_readbytes: i2c read error (addr 0x0a, err == -121)
Unknown/Unsupported NXT chip: 00 00 00 00 00
b2c2-flexcop: i2c master_xfer failed
lgdt330x: i2c_read_demod_bytes: addr 0x59 select 0x02 error (ret == -121)
b2c2-flexcop: i2c master_xfer failed
b2c2-flexcop: i2c master_xfer failed
stv0297_readreg: readreg error (reg == 0x80, ret == -121)
b2c2-flexcop: i2c master_xfer failed
mt312_read: ret == -121
b2c2-flexcop: no frontend driver found for this B2C2/FlexCop adapter
b2c2_flexcop_pci 0000:05:04.0: PCI INT A disabled
with winzoz work fine.... i try with ubunto work.

[MiniQ9]

It will work with drivers from Igor Liplianin.
http://forum.tinycorelinux.net/index.php?topic=5936.0
PS. I have compiled this one.

[exi]

if you compile for tinycore plz upload it ... i will try!!!
 
thx

[MiniQ9]

Of course.
Ups. Maximum attachment size allowed: 128 KB

[^thehatsrule^: removed, see extensions submission policy]

[exi]

send it  on megaupload or rapidshare.

[MiniQ9]

Send links by PM.

ps. 2 ^thehatsrule^ I will consider in the future.