Tiny Core Base > Release Candidate Testing

tinycore_v2.9rc2

<< < (7/8) > >>

MakodFilu:
Straight from the repo:

http://distro.ibiblio.org/pub/linux/distributions/tinycorelinux/2.x/tcz/galculator.tcz.dep

--- Code: ---atk.tcz
cairo.tcz
pango.tcz
glib2.tcz
fontconfig.tcz
expat2.tcz
libxml2.tcz
graphics-libs-1.tcz
pixman.tcz
Xlibs_support.tcz
gtk2.tcz
libglade.tcz

--- End code ---

http://distro.ibiblio.org/pub/linux/distributions/tinycorelinux/2.x/tcz/libglade.tcz.dep

--- Code: ---expat2.tcz
glib2.tcz
graphics-libs-1.tcz
libxml2.tcz
fontconfig.tcz
ttf-bitstream-vera.tcz
gtk2.tcz
atk.tcz
cairo.tcz
pango.tcz
pixman.tcz
Xlibs_support.tcz

--- End code ---

Notice ttf-bitstream-vera.tcz within libglade.tcz.dep. TC 2.8.1 didn't load it as it hadn't recursive dependency resolution, while 2.9rcX does.

Jason W:
ttf-bitstream-vera was at one point used as the default font for gtk2 apps.  It is no longer a requirement so it is not listed in many newer dep files.  Neither of those dep files in the repo were intended to be recursive.   And since extension makers have some liberty to include dependencies that may not be absolutely necessary, there are likely other ones that contain non-essential entries.

MakodFilu:
Maybe, but it just gives us an opportunity to test the recursive dependency feature.

Jason W:
Oh, ok.  I misunderstood.

robc:
The firmware isn't loading. I have the firmware-2.6.29.1-tinycore.tcz extension mounted on boot but am getting this message:
--- Quote ---e100: eth0: e100_request_firmware: Failed to load firmware "e100/d102e_ucode.bin": -2
--- End quote ---
This firmware is found in the firmware extension at /lib/firmware/e100/d102e_ucode.bin

I get the same results with the cpio and upxed kernels. depmod -ae does not fix this. Neither does a rmmod e100 then modprobe e100.

What else can I try to get this to work?

Navigation

[0] Message Index

[#] Next page

[*] Previous page