Tiny Core Extensions > TCE Talk

PCMCIA 16bit SCSI (Adaptec SlimSCSI 1460) support in TC ? (YES)

<< < (2/3) > >>

Juanito:
You can try the extension here to see if it works: http://distro.ibiblio.org/pub/linux/distributions/tinycorelinux/2.x/tcz/src/aha152x_cs/

When I load the extension and then plug in the slim-scsi card, I get these modules loaded:
--- Code: ---$ lsmod
Module                  Size  Used by    Tainted: P 
aha152x_cs             22540  1
scsi_transport_spi      9668  1 aha152x_cs
...
pcmcia                 13964  1 aha152x_cs
--- End code ---

I suspect you will need at least one more driver for your MO drive, but lets see..

libretto:
Thank you Juanito,
This is what I show:

--- Quote ---$ lsmod
Module                  Size  Used by    Not tainted
...
aha152x_cs             22540  1
scsi_transport_spi      9668  1 aha152x_cs
pcmcia                 13964  1 aha152x_cs
firmware_class       3188 1 pcmcia
...
scsi_wait_scan       260  0
....
pcmcia_core         16976  3 pcmcia, yenta_socket,rsrc_nonstatic
....

--- End quote ---

But cann't see any new device under /mnt.
You must be right, looks like another driver is needed....... :(

Dios mio maybe you can do the "make" magic one more time ? ;) ;D

curaga:
It should be shown as a normal disk (sda, sdb..). Anything in dmesg?

edit: Seems they were formatted like floppies, without a partition table. Rebuildfstab doesn't take such into account, so while a /mnt dir and a fstab entry won't appear on their own, you should still be able to mount it after creating a directory.

libretto:
Hi curaga,
Which device i should be looking at ?

--- Quote ---...
SCSI subsystem initialized
...
aha152x: resetting bus...
aha152x0: vital data: rev=1, io=0x340 (0x340/0x340), irq=3, scsiid=7, reconnect=enabled, parity=enabled, synchronous= enabled, delay=100, extended translation=disabled
IRQ 3/aha152x: IRQF_DISABLE is not guaranteed on shared IRQs
aha152x0: trying software interrupt, ok.
IRQ 3/aha152x: IRQF_DISABLE is not guaranteed on shared IRQs
scsi0 : Adaptec 152x SCSI driver: $Revision: 2.7 $
(scsi0:0:0) 01 03 01 32 08
scsi 0:0:0:0: Optical Device      MITSBISH MCA-640        1700 PQ: 0  ANSI: 2
sd 0:0:0:0: ....
...
sd 0:0:0:0: [sda] Write cache: disabled, read cache: enabled, supports DPO and FUA
   sda:
as 0:0:0:0:  [sda] Attached SCSI removable disk
sd 0:0:0:0: Attached scsi generic sg0 type 7
....

--- End quote ---

Only hdcxx under /mnt no sdaxx listed.

curaga:
Yeah, exactly as I thought in my edit.

sudo mkdir /mnt/sda
sudo mount /dev/sda /mnt/sda

To let this happen automatically, you could partition the disk.

Navigation

[0] Message Index

[#] Next page

[*] Previous page