Tiny Core Base > CorePlus

how to install a boot menu with Windows & Linux

(1/2) > >>

alino74:
Hey guys.
 I installed Tiny Core Plus v13.1 on an ext4 partition.
 During the installation I tagged to add a boot loader.
 The boot loader created previously with EasyBCD from Windows remains set, with the Linux & Windows entries: selecting Linux only opens a prompt with grub>, Windows instead starts normally.

 Could you post me a simple guide for new ones, with all the necessary steps to operate a boot menu for Windows & Tymi Core Plus already installed on a partition in Ext4?
 If simpler, modify EasyBCD appropriately (I don't know how to do it) from Windows, that's fine too.

thank you

Juanito:
What did you use to install tinycore?

Since selecting linux brings you to a grub prompt you must have a grub config file somewhere - could you copy and paste its contents here?

alino74:
i used from live tc-install and installed on an ext4 partition ..... but i don't know how to find "grub config file somewhere" ... where is it usually installed ...?

Juanito:
The file is called grub.cfg

Its location is going to depend on when it was installed and whether your machine uses a legacy bios or uefi boot - basically you are going to have to search for it.

gadget42:
haven't used easybcd but found this short read interesting nevertheless(mentions grub):
https://neosmart.net/wiki/easybcd/uefi/

Navigation

[0] Message Index

[#] Next page