WelcomeWelcome | FAQFAQ | DownloadsDownloads | WikiWiki

Author Topic: Strange Ethernet Question  (Read 8205 times)

Offline A Guy

  • Newbie
  • *
  • Posts: 25
Strange Ethernet Question
« on: August 30, 2019, 10:39:59 AM »
So let me start with , I am booting dcore 64 bit using PXE boot.
So right off the bat I am in the weeds, but I will throw this out in case there are smarter people out there.

So the issue is I can get to my boot prompt LONG before the network is working.
Now , of course, I know the network exists and everything because I am booting from it. PXE needs a DHCP resource to get an ip address and transfer the lpxelinux.0 boot image and such.

So, after the PXE boot, then Linux comes up , grabs control of the same Ethernet controller and gets an IP address (again) and then DNS information. This seems to happen 12 seconds after I am already booted (at an ash prompt)

So I guess my question is , can I get the Ethernet to come up faster? This is a fairly esoteric request, but I am just wondering if I can somehow push network init earlier in the boot process perhaps.
Maybe in a boot script I need to execute a PCI reset to the controller, so there is no old configuration info hanging around from PXE boot.

Anyone?
Tony
Tony M.
Embedded Software and BIOS Engineer

Offline neonix

  • Wiki Author
  • Sr. Member
  • *****
  • Posts: 393
Re: Strange Ethernet Question
« Reply #1 on: August 30, 2019, 01:59:30 PM »
Hi A Guy

Yes, I also noticed that getting ip address through DHCP in TinyCore is quite long. I don't know is it only with TinyCore or other systems.

You can use static ip address if your router (or other device you use for  PXE boot) allow you for this.