dCore Import Debian Packages to Mountable SCE extensions > dCore x86_64

Ethernet doesn't get IP Address

(1/1)

A Guy:
Pulled down vmlinuz-stretch64 and dCorePlus-stretch64.gz . Added them to my PXE server and booted in a virtual machine. Noticed that I didn't have an IP address.
Did this on an actual CPU and found that the same boot had an IP address.
Both will get an IP address when using the Corepure64 packages.
So :
dCoreCorepure64VMWARE PXENo IP address acquiredIP Address acquiredCPU PXEIP Address acquiredIP Address acquired
Curious if there is some delay missing for the virtual machine not to obtain an address. The dmesg command shows that the eth device found. The device is renamed to ens33 and nothing happens after that. I mean a delay doesn't make sense , obviously everything is available for VM , but I just grasping at straws.

Jason W:
Hi, I do remember having to use the boot code "waitusb=5" when running dCore in Virtualbox at one point and I believe it was for the network rather than the usb device to be found. 

A Guy:
I believe that fixed it. Now I got a pesky floppy controller not found error,but I can turn the VMs floppy on again.

Navigation

[0] Message Index