How to get crond to wait for NTP

[lnrobby]

I am new to tinycore (and linux) so this question may be simple and I just haven't found it on google.

I am using bootlocal.sh to start crond. Is there any way to wait for a good system time before it starts up?

Presently I have a sleep 30 after starting up wifi which works fine but seems a bit hit and miss.

Thanks

Len

[Greg Erskine]

hi lnrobby,

To start cron I think you should use the "cron" bootcode then /etc/init.d/tc-config handles the startup of cron at the right time.

regards
Greg

[curaga]

Look in settime.sh, there's a loop that waits until the time is not older than 2015.

[gavinmc42]

I have a shell script loop that checks for the IP address at the start.
Most of mine run behind a firewall so they needed the ip address for the local NTP server too.

There are two main files that are useful for putting these in.
bootlocal.sh and bootstart.sh if I remember right?

[lnrobby]

Got it working by using the boot code for cron.

I did have some trouble locating information on how to do this at first, and found it is dependant on the particular PI you are using.

I found this article.
/https://iotbytes.wordpress.com/change-picore-boot-codes-boot-options/

Thanks for the help

[bmarkus]

and found it is dependant on the particular PI you are using.
 

Can you explain what do you mean?

[Greg Erskine]

hi bmarkus,

Quote from linked article:

You can edit the “cmdline” file based on your Raspberry Pi Model and change the Boot Codes as per your requirements. For me, the file name is “cmdline3.txt” (as I am using Raspberry Pi 3), so I will use the following command to change Boot Codes

regards
Greg