Error while trying to load edid firmware

[qg]

Hi,

I am using the distro Tinycore 7.2 and I am trying to load a specific edid firmware. I added the options "drm_kms_helper.edid_firmware=edid.bin" to the kernel line in Grub. I am using the i915 driver (with extension graphics-4.2.9-tinycore.tcz) and I have in my kernel configuration file:

CONFIG_DRM_KMS_HELPER=m
CONFIG_DRM_KMS_FB_HELPER=y
CONFIG_DRM_I915_KMS=y

Unfortunately, I get the following error:

Direct firmware load for edid.bin failed with error -2
*ERROR* Requesting EDID firmware "edid.bin" failed (err=-11)

I looked for information on the Internet but I couldn't find anything about the error -11. Anyone had the same issue and found a solution to it ?

Thanks

[Juanito]

Ref the tinycore kernel config:

Code: [Select]

CONFIG_DRM_KMS_HELPER=m
CONFIG_DRM_KMS_FB_HELPER=y
# CONFIG_DRM_LOAD_EDID_FIRMWARE is not set
..you would need to recompile the kernel if you changed to "CONFIG_DRM_LOAD_EDID_FIRMWARE=y"

This also might be relevant:

Code: [Select]

# CONFIG_DRM_I915_PRELIMINARY_HW_SUPPORT is not set

[qg]

I changed the config to have:

CONFIG_DRM_KMS_HELPER=m
CONFIG_DRM_KMS_FB_HELPER=y
CONFIG_DRM_LOAD_EDID_FIRMWARE=y
CONFIG_DRM_I915_PRELIMINARY_HW_SUPPORT=y

and recompiled the kernel but I still have the same error.

[Juanito]

Where did you put the firmware?

[qg]

The firmware is in the /boot folder (I am using Grub as bootloader).
I am calling it with the command:

Code: [Select]

kernel /boot/vmlinuz quiet drm_kms_helper.edid_firmware=/boot/edid.bin
It looks like the file cannot be found. Where should I put it ?

[qg]

I got it working !

I had to put the file under the core.gz folder under /lib/firmware/edid and call the command

Code: [Select]

kernel /boot/vmlinuz quiet drm_kms_helper.edid_firmware=edid/edid.bin
What I was doing wrong was putting the file under /lib/firmware after the startup of the OS. So the file was under mydata.tgz and so wasn't found when booting.