My Platform Info:
root@NTPTestDevice:~# uname -a
Linux NTPTestDevice 2.6.33.3-tinycore #2 SMP Wed Jun 29 21:10:56 UTC 2011 i686 GNU/Linux
Other things to note:
root@NTPTestDevice:~# ls /sys/class/net
dummy0 eth0 eth1 eth2 eth3 lo
root@NTPTestDevice:~# cat /sys/class/net/eth0/speed
1000
root@NTPTestDevice:~# cat /sys/class/net/eth1/speed
10
root@NTPTestDevice:~# cat /sys/class/net/eth2/speed
10
root@NTPTestDevice:~# cat /sys/class/net/eth3/speed
10
I am trying to setup eth0 and eth1 slaves to a bond0.
I found this link:
https://www.kernel.org/doc/Documentation/networking/bonding.txtI am trying to do this part that it says to do:
3.3 Configuring Bonding Manually with iproute2
-----------------------------------------------
...
...
...
modprobe bonding mode=balance-alb miimon=100
modprobe e100
ifconfig bond0 192.168.1.1 netmask 255.255.255.0 up
ip link set eth0 master bond0
ip link set eth1 master bond0
Note: I had to install iproute2.tcz package to get the ip command.
The problem is, when I run the first command, I get this error:
root@NTPTestDevice:~# modprobe bonding mode=1 miimon=100
modprobe: can't load module bonding (kernel/drivers/net/bonding/bonding.ko.gz): unknown symbol in module, or unknown parameter
I found this file:
root@NTPTestDevice:~# ll /lib/modules/2.6.33.3-tinycore/kernel/drivers/net/bonding/bonding.ko.gz
-rw-r--r-- 1 root root 38104 Feb 15 16:06 /lib/modules/2.6.33.3-tinycore/kernel/drivers/net/bonding/bonding.ko.gz
How do I get past this? Or is there another way to bond these together?
The file /sys/class/net/bonding_masters does not exist, so I can't do the "3.4 Configuring Bonding Manually via Sysfs" section.
Welcome
FAQ
Downloads
Wiki
