dCore Import Debian Packages to Mountable SCE extensions > dCore X86

unable to switch from Xorg to TTY using Ctrl-Alt-F1/F2

<< < (3/5) > >>

nitram:
Sorry notice no change, boots into Fluxbox despite 'text' bootcode. Using minimal boot, all SCEs listed below built using  sce-import -z  option. After booting to Fluxbox, toggling Ctrl-Alt-F1/F2 doesn't properly switch to TTY, thanks.

--- Code: ---tc@box:~$ version
dCore-jessie:2016.02.03.23.56
tc@box:~$ showbootcodes
BOOT_IMAGE=/dCore/boot/vmlinuz-jessie nozswap text showapps tce=sdb4 desktop=fluxbox
tc@box:~$ cat /etc/sysconfig/tcedir/sceboot.lst
graphics-3.16.6-tinycore
xorg-intel
Xprogs
fluxbox

--- End code ---

Jason W:
Ok, will test.

Jason W:
Using boot codes "multivt text" boots into text, even with desktop=icewm. 

CTRL-Alt-F* switches to a new terminal login prompt.

cat /etc/sysconfit/tcedir/sceboot.lst:
pysolfc
200-multimedia-wily
wodim
minidlna
trans
flash11

nitram:
If you just use 'text' bootcode, not 'multivt text', should this not boot into text mode?

Not sure if this would make a difference but are you able to test with a dcore-jessie install?

nitram:
Just rebooted and 'multivt text' still booted into Fluxbox. IIRC previously only able to boot into TTY if i remove the tce=* and/or desktop=* bootcodes:

--- Code: ---tc@box:~$ showbootcodes
BOOT_IMAGE=/dCore/boot/vmlinuz-jessie multivt text nozswap showapps tce=sdb4 desktop=fluxbox
tc@box:~$ version
dCore-jessie:2016.02.03.23.56

--- End code ---

If someone could test on dcore-jessie it would certainly be appreciated. This is an odd problem as the 'text' bootcode works perfect on same hardware running Tiny Core 6. Oh well, can't expect my old beast to run perfect anymore :)

Jason did your successful text boot have a tce=* bootcode with a bootlist that loaded xorg?

Navigation

[0] Message Index

[#] Next page

[*] Previous page