Switch off RPi LEDs

[wigster]

Hi,

Is there any way to switch off the internal LEDs of the RPi through some software shenanigans in PiCore? I am actually running PiCorePlayer, but I hope it should be possible more generally? I am using it as an audio device and it flashes at night too much...

Thanks!

[Paul_123]

Well, the power led is direct connected to the power rail..   Everything else is likely firmware controlled.

Have you tried black electrical tape to cover them...

[sixgunz]

Not sure, but look at the firmware switch: "act_led_activelow"

[bmarkus]

It may help:

http://www.midwesternmac.com/blogs/jeff-geerling/controlling-pwr-act-leds-raspberry-pi

[Paul_123]

Not sure, but look at the firmware switch: "act_led_activelow"

This was introduced in the "+" boards.   "A+" and "B+".   I was looking at the drawing for the original Model B..

Nice Option

[sixgunz]

Ah I see. Yep only way to disable on the original is to remove the led (replace with standard diode with similar fv value.) Or tape is just as good;)

Sent from my SM-N9005 using Tapatalk