Tiny Core Base > Raspberry Pi

eth0 to wlan0 Bridge

(1/4) > >>

yeme:
I am a complete newbie to PiCore but have been using RPi for a while with my IP cameras and an eth0 to wlan0 wireless bridge.  I have followed this thread from last June:

http://forum.tinycorelinux.net/index.php/topic,18494.msg113140.html#msg113140

and am unable to figure how to proceed to make this bridge (Paul_123 has been helpful with my questions prior to this posting).

With the RPi setup I use bridge-utils to create the bridge but do not know the equivalent for PiCore and that is my question, do you have any suggestions to get me started?  I see net-bridging*.tcz and have installed it but do not know the equivalent commands. I use these commands with the RPi bridge-utils to create the bridge.

sudo brctl addbr bridge0
sudo brctl addif bridge0  eth0
sudo brctl addif bridge0 wlan0

I am using RPI B or B+

Thanks,

John

bmarkus:
Will add bridge-utils to repo in next days.

yeme:
bMarkus,

Thank you so much!

bmarkus:
bridge-utils.tcz added to 7.x repos.

yeme:
Thanks bMarkus, 

I'll give it a go.

Navigation

[0] Message Index

[#] Next page