gammu

[bellad]

hello,
i try , with gammu.tcz , put config
but i

Code: [Select]

too few parametersmy config :

Code: [Select]

[gammu]
port = /dev/ttyAMA0
connection = fbus
model = 3330
where put config file ?

picore 5.3.1

thank you

[bellad]

has anyone tried gammu on tinycore ?

[bmarkus]

It may help:

http://wammu.eu/docs/manual/config/

[bellad]

hello Béla
yes , i have doing ,
but then i start gammu ( only) or gammu with option -c /home/tc/gammurc ( i put gammurc in directory with

Code: [Select]

[gammu]
port = /dev/ttyAMA0
connection = fbus
model = 3330 ))

i have always

Code: [Select]

too few parametersas if it does not found

[bmarkus]

I used it a long time ago unfortunately, so I can't help. Check gammu.org

[Rich]

Hi bellad
Try using either gammu-detect:
http://wammu.eu/docs/manual/utils/gammu-detect.html#gammu-detect
or gammu-config:
http://wammu.eu/docs/manual/utils/gammu-config.html#gammu-config
to get a starting point for a config file.

[bellad]

thank Rich , but never
i try with sudo and tc user

Code: [Select]

/sbin/getty -L ttyAMA0 115200 vt100but

Code: [Select]

setsid operation not permittedthis may be the beginning of the problem

[bellad]

have you a solution ?

[bellad]

 i try on Raspbian , same problem
i have try , on Raspbian , with interface CP2102 USB , it's good
on TC , the problem , usb dmesg

Code: [Select]

5.223053] usb 1-1.3: Product: CP2102 USB to UART Bridge Controller
but no  /dev/ttyUSB0

on Raspbian must be
 

Code: [Select]

zgrep CP21 /proc/config.gz
CONFIG_USB_SERIAL_CP210X=m.

how to in TC ?

Thank you

[bellad]

ok , i have found : usb-serial-3.14.4-piCore+.tcz
it's good with cp21xx usb but no with serial rpi