dCore Import Debian Packages to Mountable SCE extensions > dCore X86
ub-dCore-trusty
Jason W:
Ok, the permissions seem normal in /dev. So what do you mean by xterm not working? Does it not launch, or is there a lack of command prompt?
I will make an install with that sceboot.lst and see how it does on my box.
Jason W:
I rebooted and loaded those same pakcages only, and Xterm works.
Onyarian:
They don't launch. So if I loadsce wireless, wireless-KERNEL, and wifi with the Run Program icon I can see the wifi icon but it don't launch also and after a few moments it freezes.
If I run wifi.sh with Run Program it freezes also.
All this .sce are the same from my ub-dCore in the laptop.
--------
Now I have finally make a pendrive with:
sceboot:
--- Quote ---Xprogs
xorg-all
flwm_topside
wbar
graphics-KERNEL
--- End quote ---
an sce directory with:
--- Quote ---Xprogs.sce
xorg-all.sce
flwm_topside.sce
wbar.sce
graphics-3.8.13-tinycore.sce
wifi.sce
wireless.sce
wireless-3.8.13-tinycore.sce
--- End quote ---
boot:
--- Quote ---menu label UBt-dCore
kernel /boot/utc5/vmlinuz-trusty
append initrd=/boot/utc5/ub-dCore-trusty.gz quiet waitusb=5 tce=sdb1/ubtdc5 restore=sdb1/ubtdc5 desktop=flwm_topside
--- End quote ---
and put it in the laptop, boot, and the same problem with Xterm and freeze with wifi
Jason W:
When you say these are the same sce's as ub-dCore on your laptop, do you mean these are sces that were imported on ub-dCore saucy and being run on trusty?
From the terminal not in X, run the command:
ldd /usr/bin/xterm | grep "not found"
and see what the output is.
Onyarian:
--- Quote ---When you say these are the same sce's as ub-dCore on your laptop, do you mean these are sces that were imported on ub-dCore saucy and being run on trusty?
--- End quote ---
Yes, because I don't have eth connection, only wifi, and the "http://repo.tinycorelinux.net/5.x/x86/sce/" is not operative to download the wireless tools as said in "http://repo.tinycorelinux.net/5.x/x86/README/README-wireless-tools.txt", so I have to hold the ud-dCore saucy ones.
Now I have utilized only the wireless, wireless-KERNEL, and wifi from ud-dCore saucy, put them in sceboot.lst and boot, configure the wifi connection and then importsce Xprogs, wbar, xorg-intel, graphics-KERNEL and flwm_topside, put them in sceboot.lst and reboot and this time goes OK (the modprobe error is still there)
Sorry for the non existence problem, my bad, but for people like me without eth connection is a little difficult to set the first steps, thanks that the wireless sce's from ub-dCore saucy works in trusty. Perhaps is a good idea to make operative another time the "http://repo.tinycorelinux.net/5.x/x86/sce/" with only the wireless sce's for every distribution and actualize the information from "http://repo.tinycorelinux.net/5.x/x86/README/README-wireless-tools.txt".
Thanks for your patience Jason.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version