Tiny Core Extensions > TCE Corepure64

64 bit and windows manager

(1/6) > >>

null:
I appologise if this had been posted before.  I have always used TCL in it's ISO form to boot (directly boot iso from USB, always USB).

I had a chance recently to try out the 64bit TCL, and knowing there's no ISO for this, need to do a bit of install/config.

This is what I have done:
1. Format usb stick in ext2 / ext4 (I have tried a few installs by now)
2. Install grub2 onto stick
3. copied the corepure64 and vmlinuz64 onto usb  root folder.
4. grub2 booted 64 bit.

Now I have tried to get the windows manager up, but without luck. I tried fluxbox and flwm downloaded these TCZs and did tce-load, etc.

When I tried to run fluxbox, I get Cannot connect to XServer or Cannot connect to XServer with null display.

I have trolled through the forum, but can't seem to find a step by step guide to get the windows manager to start in 64 bit TCL.

I am running 64 TCL on a dell inspiron with Corei7.

Sorry if this is a very easy thing to do, but I am new to the 64bit setup.

gerald_clark:
You must use the corepure64 repo.  Just install the wm over the internet.
tce-load Xvesa Xprogs flwm wbar

Juanito:
There's no 64-bit Xvesa, it would need to be Xorg-7.6

null:

--- Quote from: gerald_clark on July 14, 2013, 10:41:07 PM ---You must use the corepure64 repo.  Just install the wm over the internet.
tce-load Xvesa Xprogs flwm wbar

--- End quote ---

Hi GC,

is the repo:

tinycorelinux.net/4.x/x86_64/tcz?

Juanito:
affirmative

Navigation

[0] Message Index

[#] Next page