Tiny Core Extensions > TCE Talk

syslinux upgrade for tc4.7.x?

<< < (9/9)

genec:

--- Quote from: gmc on June 16, 2013, 01:35:39 AM ---The NSLU2 is rather limited in what it allows the end user to configure.  It insists on asking for a user name/password for any access.  Failed logongs are supposed to default to the "guest" account.

--- End quote ---
Unrecognized requests with the Authorization header, yes.  Without the header it's a failure with HTTP stastus 401.


--- Quote ---At the PXE boot menu, when I select an entry from the menu and press Enter, I need to see the response/error message before PXE returns to the menu (assuming a boot failure occures, which it does when trying an http boot).  As it is, I see just the briefest flash of a message and then it is gone and the menu is active again.

--- End quote ---
Working as intended.  You'd need a ONERROR command specified and COM32 module to pause the screen or try without the menu.



--- Quote ---I am currently trying that.  So far I just replaced lpxelinux.0 with undionly.kpxe (in udhcpd.conf) per the ipxe setup instructions.  I get the ipxe boot screen and can Ctrl-b to break out of the endless loop (again, per the instructions).  I have not gotten any further yet, still reading.  I was hoping that it would run the 'default' menu by default but it looks like I have to do some more configuration to get to that point.

--- End quote ---
Just like gpxelinux.0/ipxelinux.0: add a script and possibly pxelinux.0.  At that point, try the URL with username/password in the PXELINUX config.

gmc:
@genec - Very useful information.  I managed to get an http boot to work with ipxelinux.0, thanks.  I'm still hoping to get it working with syslinux but now I have another option to fall back on for the present.  All the tips were what I needed, thanks.

I'm presently trying to get a second NSLU2 I picked up upgraded to openwrt firmware.  That should allow me to have the control needed to work with syslinux http booting.  The reflashing went OK, but I could not get an IP address to the unit.  I off to work on that now...

Navigation

[0] Message Index

[*] Previous page

Go to full version