dCore Import Debian Packages to Mountable SCE extensions > Allwinner A10

Cubieboard Install

<< < (2/8) > >>

Redhair:
Thanks for your help! I've ordered a new card...

roberts:
Before writing the image to sdcard, often I will zero out the beginning of a card. Sometimes it has helped with troublesome cards.
dd if=/dev/zero of=/dev/sdX bs=1M count=50

Redhair:

--- Quote from: roberts on March 25, 2013, 11:47:40 PM ---Before writing the image to sdcard, often I will zero out the beginning of a card. Sometimes it has helped with troublesome cards.
dd if=/dev/zero of=/dev/sdX bs=1M count=50

--- End quote ---
I've tried this with the same old card and it's working, thanks a lot!

Barmallini:
I have problem with Cubie and TC.
Cloned a10Core-20130510.img to SDHC (4Gb) via DD. All fine. Cubie loaded, but no prompt.
Tryed different USB-VCP cables, nothing. Commands sended (ls, cd and so on), but no echo and nothing happens.
Default firmware work fine. After loading i have command prompt like ordinary Linux.

Any idea?

Changed tty0 to ttyS0 - does not help.
This uEnv from original Tom's distro (console working fine):
extraargs=console=ttyS0,115200 console=tty0 disp.screen0_output_mode=1280x720p60 hdmi.audio=EDID:0 mmc0_led=1 mac_addr=ca:28:f0:49:3e:7d rootfstype=ext4 bootdelay=1

Top USB does not work too in TC. I put USB flash to bottom USB - its detected, put it to top - nothing happens. Tom's distro detects both USB sockets (first time i thinked cubie is broken).

P.S. Log (CRC error):

U-Boot SPL 2013.01 (Feb 08 2013 - 13:16:49)
Board: Cubieboard
DRAM: 1024MB
SUNXI SD/MMC: 0


U-Boot 2013.01 (Feb 08 2013 - 13:16:49) Allwinner Technology

CPU:   SUNXI Family
Board: Cubieboard
I2C:   ready
DRAM:  1 GiB
MMC:   SUNXI SD/MMC: 0
*** Warning - bad CRC, using default environment

In:    serial
Out:   serial
Err:   serial
Net:   wemac

roberts:
Don't have the debug board or comm port (virtual or otherwise) to test serial output. Works with hdmi

Navigation

[0] Message Index

[#] Next page

[*] Previous page