stuck in mid boot

[Vind]

Hi
to start, i am non English and very new to linux, so very sorry if this doesn't make any sense.

I am trying to live boot from a usb drive on a HP Compaq t5520 Thin Client
Processor:    VIA 800 MHz
Flash:            64 MB
Memory:           128 MB DDR SDRAM
Graphics:           VIA S3 graphics with support for high-resolution monitors up to 1280 x 1024
(NOTE: 16 MB of system RAM is reserved for video graphics usage)
The terminal doesn't have a hard drive, just ram

I have today downloaded the "CorePlus-Current.iso" and used "Universal-USB-Installer-1.9.0.9" to install it on a 4gb flash drive.

It boots fine to the boot options, but CorePlus and the TinyCore (boath GUI and non-GUI) stops after it has whiten:
"
Booting Core 4.6
Running Linux Kernel 3.0.21-tinycore.
Checking boot options...Done.
Starting udev daemon for hotspot support...Done.
Scanning  hard disk partitions to create /etc/fstab
Setting Languae to C Done.
"
Then there is just a white marker, that echo's the buttons i pres.
i have left it alone for about 10 min, nothing happens.
this is also when i use the mode for slow usb drives.

i have tried using the boot options f.eks. the vga= and set lang= but nothing helps.

i hope you can help me, or end my suffering and tell me it ill never work.
/Vind
 

[Rich]

Hi Vind
I would like to suggest you try using  core2usb  found here:
http://sourceforge.net/projects/core2usb
It was written specifically for installing Tinycore to a usb stick from a Windows environment.

[curaga]

In addition to using a supported installer like Rich said, please try with the bootcode "debug", what messages do you see. You can add bootcodes by pressing tab at the boot options menu.