Release with vmware view client; where i parameter?

[masterx]

hi, i hava a version tiny core maked by vmwaredotg.com with vmware view client
it's go and open this application
where i set the parameter (example the IP ) ; there is a file's configuration?

thanks

[curaga]

Please go to the remaster's site for support for it.

[Rich]

Hi masterx
Click on the ControlPanel icon and open the Network applet.

[masterx]

thanks at all

the site is off-line at this time. do you have notice when go on-line?

i haven't control panel because this version is a version with thin client only.

[Rich]

Hi masterx

the site is off-line at this time. do you have notice when go on-line?

That site was create by someone else and is not associated with tinycorelinux.net, see:
http://forum.tinycorelinux.net/index.php/topic,13485.msg74916.html#msg74916

Create a script called  eth0.sh   in  /opt  that contains the following:

Code: [Select]

#!/bin/sh
pkill udhcpc
ifconfig eth0 192.168.1.30 netmask 255.255.255.0 broadcast 192.168.1.255 up
route add default gw 192.168.1.1
echo nameserver 68.237.161.12 > /etc/resolv.conf
echo nameserver 71.243.0.12 >> /etc/resolv.confAdjust  eth0  and the IP addresses to match your system. Run the script and your network card should be configured.
Add a line that looks like:

Code: [Select]

/opt/eth0.shto your  /opt/bootlocal.sh  file. This will set up your network card every time you boot.
Be sure to read the Wiki on how to backup these changes.