WelcomeWelcome | FAQFAQ | DownloadsDownloads | WikiWiki

Author Topic: Ralink RT5390 WiFi not working  (Read 1759 times)

Offline NinjaCowboy

  • Newbie
  • *
  • Posts: 36
Ralink RT5390 WiFi not working
« on: January 11, 2019, 03:26:39 PM »
I'm trying to run Tiny Core Linux on a HP laptop. This laptop has a Ralink RT5390 Wireless card in it, as shown by this output of 'lspci -k' run in Linux Mint.
Code: [Select]
01:00.0 Network controller: Ralink corp. RT5390 Wireless 802.11n 1T/1R PCIe
        Subsystem: Hewlett-Packard Company U98Z077.00 Half-size Mini PCIe Card
        Kernel driver in use: rt2800pci
        Kernel modules: rt2800pci
However when I boot up Tiny Core and load the rt2800pci module (modprobe rt2800pci), it doesn't seem to enable my WiFi card at all. 'ifconfig' just lists the eth0 and lo network interfaces (no wlan0), and 'rfkill list all' shows no output.

Offline coreplayer2

  • Hero Member
  • *****
  • Posts: 3020
Re: Ralink RT5390 WiFi not working
« Reply #1 on: January 11, 2019, 06:01:58 PM »
Hi Ninjacowboy

After loading rt2800pci module copy and post here the last 10 lines from “dmesg” output




Sent from my iPhone using Tapatalk

Offline NinjaCowboy

  • Newbie
  • *
  • Posts: 36
Re: Ralink RT5390 WiFi not working
« Reply #2 on: January 11, 2019, 07:38:03 PM »
Sorry, my flash drive got corrupted again. I'll have to reinstall a third time.

Offline coreplayer2

  • Hero Member
  • *****
  • Posts: 3020
Re: Ralink RT5390 WiFi not working
« Reply #3 on: January 11, 2019, 08:45:15 PM »
Hi
Most likely you'll need the ralink firmware extension installed

firmware-ralinkwifi.tcz