WelcomeWelcome | FAQFAQ | DownloadsDownloads | WikiWiki

Author Topic: Alsaconf Audio change output device card  (Read 3381 times)

Offline rizla

  • Newbie
  • *
  • Posts: 2
Alsaconf Audio change output device card
« on: February 20, 2014, 04:16:08 PM »
Hi all,
i'm a newbie of all linux distribution.
I have a little problem with TinyCore Pluse, internal sound card not work  :'(
The issue is that my laptop have two sound card:
1) HDMI Output Radeon
2) Hudson Azalia Controller sound card

I download ALSA and alsaconf extention, execute alsaconf and it found sound card "Hudson Azalia Controller",but  the primary output is always "HDMI Output Radeon".
I run speaker-test but there is no sound.

I'm sure sound card works fine and exist linux driver, because with other linux distribution works fine.
can anybody help me?

rizla



« Last Edit: August 15, 2021, 04:49:30 PM by Rich »

Offline Rich

  • Administrator
  • Hero Member
  • *****
  • Posts: 11178
Re: Alsaconf Audio change output device card
« Reply #1 on: February 20, 2014, 06:52:41 PM »
Hi rizla
The lower right window in your screen shot shows the master volume is at -65dB which is all the way down.

Offline tinypoodle

  • Hero Member
  • *****
  • Posts: 3857
Re: Alsaconf Audio change output device card
« Reply #2 on: February 20, 2014, 06:59:25 PM »
Not only that - it's actually muted   :o

(Press "M" to unmute)
"Software gets slower faster than hardware gets faster." Niklaus Wirth - A Plea for Lean Software (1995)

Offline rizla

  • Newbie
  • *
  • Posts: 2
Re: Alsaconf Audio change output device card
« Reply #3 on: February 21, 2014, 05:56:11 AM »
Hi all,
Yesterday, I also thought it was the fact of being mute.
But I unlocked the mute and put all parameters to the maximum, not works.

I think it is always set as the primary output HDMI and I can not change it to Hudson Azalia.

If you look at the bottom left of the image shows the "ALSA mixer GUI" on HDMI device, and I can not change it to Azalia.
Addition Azalia is not  HDMI output, but it is the motherboard sound card..

How can I change the primary sound output towards Azalia?


thank you for response  :)
« Last Edit: February 21, 2014, 06:02:20 AM by rizla »

Offline Juanito

  • Administrator
  • Hero Member
  • *****
  • Posts: 14516
Re: Alsaconf Audio change output device card
« Reply #4 on: February 21, 2014, 06:27:57 AM »
It's probably a good idea to visit the official alsasound site and check out the support resources there.

Another possible solution is to use pulseaudio/pavucontrol - I hesitate to suggest this is it is a bunch of bloat and complication, but it does make it easy to switch between sound sources and outputs